Ideally suited for the removal of ground water from basements and cellars. Sold in manual and automatic versions and can be purchased as pumps only, or as a key component in our packaged pumping systems.
Automatic (P31), Manual (P29)
Automatic (P32), Manual (P28)
Automatic (P33), Manual (P27)
The unique vertical operation float switch ensures that the pumps operate within their footprint, removing the possibility of the float snagging during operation and allowing the pumps to be used within smaller sumps.
The vertical float switch is also very flexible, allowing the pump switching height to be adjusted between the ‘on’ and ‘off’ positions, as well as the height relative to the pump. The Newton CP Pumps are suitable for use with Newton Victron Power Inverters to give continual pumping even during power outage.
The Newton CP series pumps are sold in both manual and automatic versions and can be purchased as pumps only, or as a key component in our packaged pumping systems.
Thermal overload protection against motor burnout
Non-clogging vortex impeller
Protection against motor burnouts due to a locked impeller
Double mechanical seals ensure increased durability against particle abrasion and wear
Anti-airlock impellor housing ensures that the pump is able to remove trapped air even when the sump was previously dry
High performance and efficiency even with a low current
Unique vertical float allows complete adjustment of the start and stop heights
Continued pumping even during power cuts when used with Newton Power Converters
Primarily designed to be used with Newton sump systems for the removal of ground water collected by Newton System 500 basement waterproofing system, Newton CP pumps can also be used for the removal of water from:
Flooded basements and cellars
Surface drainage collection vessels
Reservoirs and water holding vessels
Newton CP Pumps are supplied with a 1-year manufacturers warranty or a 3-year back-to-base warranty if the pumps are serviced by a Newton approved service engineer.