The Titan-Pro packaged sump system is designed specifically to be used with Newton System 500. The adjustable neck allows for the sump to be installed at a fixed height relative to the slab.
Featured Case Studies
The Titan-Pro packaged sump system is designed specifically to be used with Newton System 500.
The adjustable neck allows for the sump to be installed at a fixed height relative to the slab so that the connection in from the Newton drainage system and the pump discharge line are made above the concrete, and always at the same height relative to the slab or raft.
The sump can be used with single and twin pumps and twin pumps with twin discharge lines for greater pump efficiency.
The unique sump shape together with a choice of inlet and outlet positions allow for connections in and out of the chamber to be made to either a side wall or to a corner.
Compatible with a large number of Newton NP and CP clean water pumps
Fully built system includes all internal pipe and pipe fittings ready for 50 mm or 63 mm rising main
One-way valve for each pump included
Two quick release couplings per pump for easy installation and removal for servicing
Adjustable neck ensures that the lid is always at the correct height regardless of floor finishes
Newton PA50 High Water Level Alarm included with pump and pipe kits (TP3 - TP47)
Supplied with sealed and locked recessed lid. High end finish lids and frames are available as cost options
Flat areas to side of chamber ready for wall flanges to receive incoming 110 mm drainage pipes. Wall flanges are available as cost options
Large foot to base of chamber to prevent flotation
Anti-Drip system available for the inside of the chamber
Anti-Smell system available for when the sump is receiving water from washing machines, sinks or dishwashers
Wet-Install kit for installations where water is entering the excavation. 110mm Tremie pipe required (not included)
The Titan-Pro is specifically designed to be used with Newton System 500, our ‘Type C’ cavity drain waterproofing system.
BS 8102:2009 the British Standard for Waterproofing
The British Standard 8102:2009 Code of Practice for Protection of Below Ground Structures Against Water From the Ground is the main design guide for structural waterproofing in the UK.
Newton System 500 is a maintainable system, so complies with BS 8102 requirements. BS 8102 also specifies that “a waterproofing specialist should be included as part of the design team so that an integrated waterproofing is created”
Therefore it is our recommendation that Newton System 500 is installed by a Newton Specialist Basement Contractor (NSBC).
“In the world of waterproofing, specifiers and architects, Newton Waterproofing systems products are class leading. And a vast range of well researched pumping and control systems to complement the industry”
London Basement Pumps